‘In every window replacement, make sure to check both sides for the plumb,’ says Robert Johnson, founder of Sawinery. Check the window is plumb and level and adjust shims if necessary. Make sure the exterior stop molding (blind stop) is in good condition, and replace it if this is not the case.ĭry fit the window by centering it in the opening (you may want someone to help you with this stage). Fill any holes, too and replace any areas that are damaged. Prepare for the new window and dry fitĬheck the opening and remove all caulk around it. Remove any protruding fasteners, and pull out any metal channels around the window.ģ. Remove the fasteners that secure the old window to the frame if your window has any cords or chains and weights, cut these and remove them. ![]() Wearing safety goggles and work gloves, take out the existing window.Īpply painter’s tape to any cracked panes of glass for safety, then remove the interior stop molding with care and set aside for possible re-use. The window needs to be around 0.75 inches (19mm) smaller than the opening. Use the smallest measurement for both height and width when you’re buying a new window. Then measure the width of the window frame from the outside edge of the stop molding to the other outside edge in the middle and at top and bottom. Measure in the center of the window and on either side, and note each measurement. ![]() Measure the height of the existing window frame from where the bottom sash meets the sill to where the top sash meets the head. ![]() It is essential to measure in more than one place. In order to purchase a remodel window of the right size, you’ll first need to measure the window opening. If your new window has installation instructions that differ from ours, make sure you follow these for correct installation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |